Research undertaken into PIM resulted in the publication of the white paper ‘Connector Related PIM’ from Hughes Electronics and the Biomedical and Communications (BiMEC) research group at London South Bank University last year - suggesting that standard metre denominated lengths of cables are rarely phase congruent with commonly used (cellular telecom) frequencies and cause higher levels of PIM than are necessary.
PIM is a series of resulting signal harmonics and distortions that emerge between two or more interacting signals when transmitted through passive components such as cables and connectors, causing unwanted interference and degradation of wireless communications.
4G, 5G and Future Generation Networks require stricter Signal to Noise Ratios (SNRs) and the issue of PIM has to be addressed if cellular capacity is to be maintained.
According to Greg Rymar, head of research and product development at Hughes Electronics, “During our prior research into connector related PIM we discovered that small adjustments to cable length made a significant difference to PIM results, in particular we found that industry standard Jumper and feeder cables denominated in multiples of 0.5 or 1 metre lengths, did not produce the most desirable results when it came to PIM.
“Our investigations showed the reason for the phenomenon was that these standard cable lengths are not in harmony with frequency wavelengths i.e. the cable length does not match the compound length of the carrier frequency Sine Wave causing ‘phase offsets’ and triggering phase angle reflections which can be seen as PIM.
“In addition, each reflection causes a loss of amplitude (VSWR) to the received signal and Inter-Modulation (IM) becomes more acute as a result of the difference in power between transmitted and receive signals. The more impoverished received signal strength is, the more vulnerable it is to PIM distortion levels.”
As a result of the research Rymar concluded that calculating overall phase displacement and adjusting cable length to harmonise phase in the operating frequency range was “a must for improving PIM performance.”
In response Hughes Electronics have now added a length calculation service to their Network Approved rapid reaction non-standard jumper cable manufacturing service. The addition of the new service provides clients with the performance advantage of frequency and phase matched cables.
Hughes frequency matched jumper cables are factory prepared in Hughes’ central London workshop in which state of the art high temperature inductive soldering is used and incorporates an IP68 gas tight moulded finish.
